Dec 23, 2019 · I have been trying to simulate a VCO for a CB radio on LTspice, but cannot get it to run. The ac analysis give me a peak at about 3.5 MHz but cannot get anything from the .trans. It is …

Feb 15, 2013 · Hi, I wrote UART code that sends UART data to the PC. I want to simulate it and therefore need to see a terminal that will present the data being sent to the PC from the PIC during …

Nov 9, 2018 · I'm attaching an LTspice file that simulates a crystal oscillator with resonant frequency 1MHz, and it works fine. But if I change L1 from 2.5 H to 9.8 mH to simulate a crystal oscillator with …

Apr 19, 2025 · Hi everyone! We’re opening this special thread dedicated to sharing fully simulatable examples using the OshonSoft IDE, perfect for those who program in PIC Basic as well as for those …

Mar 27, 2015 · Hello I tried to simulate a NTC thermistor with Orcad Pspice lit. following some models found on the web, I replaced the NTC by a VCCS with gain depending on TEMP. Netlist is joined but …

Jul 26, 2016 · In connection with this other thread, I developed LTspice simulation models respectively for single and dual-coil DPDT latching relays, based on data from...

Jul 7, 2010 · You cannot simulate a motor or a globe. Both take a very high current at the beginning and the driving device plus the power supply must be able to deliver this current.

May 9, 2017 · Hi everyone, I am using LTSpice IV version 4.231. I have a polynomial fit to a current-voltage characteristic curve and would like to simulate in LTSpice using B sources. The polynomial fit …

Mar 19, 2010 · Opamp2 is the symbol you use when you want to simulate a model from another mfr. For an ideal op amp need to use the opamp symbol, and add the directive ".lib opamp.sub" to the …

Dec 23, 2015 · Hello I make a simple simulation of a dc current source applied on a 10 Kohms thermistor. When I perform a transient simulation (I1 = 10 mA until 10 s) , the thermistor warms up …